Cisco WS-X5162 매뉴얼 - 페이지 8
{카테고리_이름} Cisco WS-X5162에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X5162 33 페이지. Configuring token ring lan emulation
Cisco WS-X5162에 대해서도 마찬가지입니다: 제품 지원 게시판 (6 페이지)
페이지 인쇄
Default LANE Configuration
•
•
•
Note
The last three items in the list above are important because they determine how you set up each ELAN in
the LECS database.
•
Default LANE Configuration
The table below shows the default LANE configuration.
Table 1
Feature
LANE components
PVCs
Preferred PHY (Dual PHY modules only)
Output throttling
ILMI keepalives
UNI version
VTP
Configuring the ATM Module from the Terminal
To configure the ATM module from the terminal, use the following commands beginning in privileged
EXEC mode:
SUMMARY STEPS
1. ATM# configure terminal
2. ATM(config)# interface atm>elanname
3. ATM(config-if)# lane client tokenring>elanname
4. ATM(config-if)# Ctrl-Z
5. ATM(config)# write memory
8
Names of the ELANs that will have unrestricted membership.
Names of the ELANs that will have restricted membership.
Local segment ID for the ELAN. The local segment ID must be identical to the ring number of the
TrCRF.
Default LANE Configuration, page 8
Default LANE Configuration
Configuring the ATM Module from the Terminal
Default Value
No LECS database is configured.
No LES/BUS is configured.
No LECs are configured.
ILMI and signalling PVCs are set up.
PHY A
Disabled
Disabled
Autonegotiate (reverts to UNI 3.0 if autonegotiation
fails)
Disabled