Cisco WS-X5168 매뉴얼 - 페이지 27

{카테고리_이름} Cisco WS-X5168에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X5168 33 페이지. Configuring token ring lan emulation
Cisco WS-X5168에 대해서도 마찬가지입니다: 제품 지원 게시판 (6 페이지)

페이지 인쇄
Cisco WS-X5168 매뉴얼

Verifying the LANE Setup

47.00918100000000E04FACB401.00100DAACC41.01
ATM(lane-config-database)# default-name default
ATM(lane-config-database)# ^Z
ATM# show lane database
LANE Config Server database table 'LANE_Backbone'
default elan: default
elan 'default': un-restricted
server 47.00918100000000E04FACB401.00100DAACC41.01 (prio 0)
Verifying the LANE Setup
Once you have set up the LECs on the subinterfaces of an ATM module, you can display their ATM
addresses by using the following command in privileged EXEC mode:
Command
Router#
The command output shows all the subinterfaces configured for LANE. For each subinterface, the
command displays and labels the ATM addresses that belong to the LES, BUS, and the LEC.
When you look at each ATM address, confirm the following items:
•
•
•
Enter the show lane EXEC command on each Catalyst 5000 series switch to verify the LANE setup before
you set up the LECs on the next Catalyst 5000 series switch. Print the display or make a note of these ATM
addresses so that you can use it when you set up the LECS database. At this point in the configuration
process, the LECs are not normally operational.

Monitoring and Maintaining LANE Components

After configuring LANE components on an interface or any of its subinterfaces, you can display their status
on a specified subinterface or on an ELAN. To show LANE information, issue the following commands in
privileged EXEC mode:
Command
Router#
[subinterface-number
|
]] [
Router#
[subinterface-number
] |
] [
show lane
The prefix is the one you set up on the switch.
The end-system identifier field reflects the base address of the pool of MAC addresses assigned to the
ATM interface plus a value that represents the specific LANE component.
The selector byte is the same number as the subinterface (converted to hexadecimal).
show lane
interface atm 0
[
name
elan-name
brief
]
show lane bus
interface atm 0
[
name
elan-name
brief
]
Configuring Fast SSRP for Redundant LANE Services
Purpose
Displays the LES, BUS, and LEC ATM addresses.
Purpose
Displays the global and per-VCC LANE
information for all the LANE components and
ELANs configured on an interface or any of its
subinterfaces.
Displays the global and per-VCC LANE
information for the BUS configured on any
subinterface or ELAN.
27