Cisco WS-X6066-SLB-APC - Content Switching Module 설치 참고 사항 - 페이지 16
{카테고리_이름} Cisco WS-X6066-SLB-APC - Content Switching Module에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X6066-SLB-APC - Content Switching Module 28 페이지. Catalyst 6500 series switch content switching module
페이지 인쇄
Installing the CSM
Figure 3
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create
c.
a small (0.040 inch [1 mm]) gap between the EMI gasket and the module above it. (See
Pressing down too firmly on the levers will bend and damage them.
Caution
While pressing down, simultaneously close the left and right ejector levers to fully seat the
d.
supervisor engine or module in the backplane connector. The ejector levers are fully closed when
they are flush with the module faceplate. (See
Catalyst 6500 Series Switch Content Switching Module Installation Note
16
Clearing the EMI Gasket in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
3
Press down
4
WS-X622 4
5
24 PORT 100FX
6
3
4
4
WS -C6 500 -SF
M
5
5
SW ITC H FAB IRD
MD L
6
6
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
1 mm
Gap between the module
EMI gasket and the
module above it
Figure
4.)
PORT 2
PORT 2
Press down
Figure
78-15751-03
3.)