Cisco 3600 Series 업그레이드 지침 - 페이지 23

{카테고리_이름} Cisco 3600 Series에 대한 업그레이드 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3600 Series 30 페이지. Memory upgrade
Cisco 3600 Series에 대해서도 마찬가지입니다: 제품 개요 (10 페이지), 소유자 매뉴얼 (17 페이지), 애플리케이션 노트 (41 페이지), 구성 매뉴얼 (36 페이지), 사용자 설명서 (25 페이지), 부록 (15 페이지), 사용자 설명서 (7 페이지), 매뉴얼 (5 페이지), 구성 참고 사항 (23 페이지), 구성 참고 사항 (18 페이지), 구성 참고 사항 (25 페이지)

Hold the SODIMM component-side up, with connector edge (the metal fingers) away from you. Keep

Step 3

the sides of the SODIMM between your thumb and middle finger, with your forefinger against the far

edge and opposite the connector edge. (See

Figure 11

Tilt the SODIMM to the same angle as the socket, then insert the connector edge into the socket. Gently

Step 4

push into place until the plastic clips snap into place.

Caution

It is normal to feel some resistance when installing a SODIMM, but do not use excessive force and do

not touch the surface components.

Check the two alignment holds and ensure that the plastic clips are visible. If necessary, carefully remove

Step 5

and reseat the SODIMM.

If necessary, repeat

Step 6

Proceed to either of the following as appropriate:

Step 7

•

Replacing CompactFlash Memory Cards

To install a new CompactFlash memory card, follow these steps:

Refer to Installing and Formatting Cisco 2691, Cisco 3631, and Cisco 3700 Series CompactFlash

Step 1

Memory Cards, available online at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3700/hw_inst/hw_notes/

index.htm

Proceed to

Step 2

OL-5423-02

Handling a SODIMM

Step 3

through

"Replacing CompactFlash Memory Cards" section on page 23

"Replacing the Cisco 3745 Mainboard" section on page 24

"Replacing the Cisco 3745 Mainboard" section on page

Upgrading System Memory in Cisco 3745 Routers

Figure

11.)

Step 5

to install the top SODIMM.

Upgrading System Memory in Cisco 3700 Series Routers

24.