Cisco 522 사용자 설명서 - 페이지 15

{카테고리_이름} Cisco 522에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 522 46 페이지. Ip phones with multiplatform firmware
Cisco 522에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 설치 매뉴얼 (39 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

Your Headset

Number

You select which call source you want to use with the call source controls on the Multibase. The LED next

to each selected source lights up when the source is selected.

Even if you are connected to a source, the LED may not be lit. The source LED only lights when the source

is selected or has an active call. For example, you may be properly connected to a Cisco IP Phone, your PC,

and your mobile phone through Bluetooth. However, the respective source LED is only lit when it is selected,

has an active call, or has an incoming call. Press the source button to check if a source is properly connected.

The source LED flashes three times if there is no connection.

You can alternate between active call sources.

Note

Place an active call on hold before you change to a different call source. Calls on one call source aren't

automatically put on hold when you switch to a different call source.

Name

Call Status LEDs

Mute Status LED

Bluetooth Status LED

Cisco Headset 560 Series Multibase

Description

Alerts you to the call state:

• Active Source—Steady white

• Incoming call—Blinking green

• Active call—Steady green

• Incoming call on an unselected source—Pulse green

Alerts you when your headset is muted.

Alerts you to the Bluetooth status:

• Paired with a call source—Steady white

• Pairing mode—Blinking white

• Searching for a call source—Pulse white

• Bluetooth is Off—LED is blank

Cisco Headset 500 Series User Guide