Cisco 6800 Series 하드웨어 설치 - 페이지 11

{카테고리_이름} Cisco 6800 Series에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 20 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 유지 관리 매뉴얼 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Hardware Installation

Step 9

If required, plug the power adapter into the electrical outlet.

What to do next

Do one of these:

• Base station installation:

• Repeater installation:

Mount the Base Station or Repeater on a Desk

You can place the base station or repeater on a desk or other horizontal surface (for example, a book shelf).

Select a location where the base station or repeater won't be easily knocked off.

The base station and repeater have a range of up to 984 feet (300 meters) outdoors and a range of 164 feet

(50 meters) indoors.

In this task, the term device means the base station or repeater.

Before you begin

You need:

• Base station: LAN connection close to the mounting location.

• Base station: If you do not use PoE, a power outlet close to the mounting location.

• Repeater: A power outlet close to the mounting location.

• Ensure that the base station can communicate with the network (see

Determine the best placement, taking into account the coverage area and the building construction materials.

• If you have a 210 Multi-Cell Base Station, you may need to add additional base stations or repeaters.

• If you have a 110 Single-Cell Base Station, you may need to add 110 Repeaters.

You can use the site survey tool on the handset to plan placement.

Procedure

Step 1

Base station only: Connect the Ethernet cable to the device and route the cable through the slot in the device.

Step 2

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Manual configuration:

• Automatic configuration:

Add a Repeater

6). After it can communicate and the LED is green, you can unplug the cables if you haven't tested the

base station in the final location.

Sign into the Administration Web Page

Mount the Base Station or Repeater on a Desk

and

Configure the Base Station

and

Start Handset Registration

Install the Base Station, on page

Hardware Installation