Cisco 6800 Series 하드웨어 설치 - 페이지 6

{카테고리_이름} Cisco 6800 Series에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 20 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 유지 관리 매뉴얼 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Cisco 6800 Series 하드웨어 설치
Handset Package Contents
If you want to mount the repeater on the ceiling, you need to order a separate ceiling mount kit.
Handset Package Contents
Your handset package has the following contents:
• Handset with attached belt clip. Inside the handset is the battery, with a piece of plastic over the battery
• Charging cradle with attached USB cable.
• Regional power adapter for the charging cradle.
• Plastic cover to replace the belt clip on the handset.
• Printed compliance document.
You need the label on the box during handset registration.
Power Requirements
The base station requires one of these power sources:
• Power over Ethernet (PoE) - minimum IEEE 802.3: Power class 2 (3.84 – 6.49W)
• Power adapter specific to your region with a USB-to-power jack cable. The power adapter is plugged
The handset is powered by a 3.7V, 1000mAh, 4.1Wh, Lithium ion battery.
The handset charger power cable plugs into the regional power adapter, and the power adapter must be plugged
into an electrical outlet.

Install the Base Station

When the base station connects to the network, the LEDs light to indicate the network status:
• Green—Connected.
• Amber—Connection in progress.
• Red, flashing—Can't connect to the network.
Hardware Installation
6
contacts.
Note
You need to remove the plastic over the battery contacts. For more information,
see
Install the Battery in the Handset, on page
Note
Make sure that you save this small plastic cover, in case you want to use the
handset without the belt clip.
into an electrical outlet.
Hardware Installation
16.