Cisco 6800 Series 하드웨어 설치 - 페이지 7

{카테고리_이름} Cisco 6800 Series에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 20 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 유지 관리 매뉴얼 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Cisco 6800 Series 하드웨어 설치
Hardware Installation
• Red, solid—Network connection resetting.
Use this procedure to check that the base station and the network can communicate with each other, before
you mount the base station in the chosen location.
Before you begin
The base station requires:
• Power over Ethernet (PoE) or a power adapter
• LAN connection
• An IP address assigned by DHCP in the network
Procedure
Step 1
Plug one end of the Ethernet cable into the base station.
Step 2
Plug the other end of the Ethernet cable into the LAN port.
Step 3
If you don't use PoE, plug the power adapter into the base station and then into the electrical outlet.
Step 4
If the LED flashes red after a few minutes, do these steps:
a) Locate the Reset button on the bottom edge of the base station.
b) Press and hold Reset until the LED is a solid red.
c) Release Reset.
The LED should flash amber and then try to connect. If the LED doesn't light green, then the base station
can't get an IP address. See
What to do next
Mount the base station with one of these procedures:
•
•
•

Mount the Base Station or Repeater on the Ceiling

You can mount the base station or repeater on a ceiling. They use a custom ceiling mount bracket that you
can install on the ceiling. You need to order the ceiling mount bracket.
Base Station LED is Solid Red
Mount the Base Station or Repeater on the Ceiling, on page 7
Mount the Base Station or Repeater on a Desk, on page 11
Mount the Base Station or Repeater on the Wall, on page 12
Mount the Base Station or Repeater on the Ceiling
for further help.
Hardware Installation
7