Cisco 6800 Series Instalação de hardware - Página 7

Procurar online ou descarregar pdf Instalação de hardware para Telefone IP Cisco 6800 Series. Cisco 6800 Series 20 páginas. Ip phone, multiplatform phones
Também para Cisco 6800 Series: Manual de início rápido (3 páginas), Manual do utilizador (8 páginas), Manual de manutenção (8 páginas), Manual do utilizador (14 páginas), Manual de resolução de problemas (12 páginas), Manual de início rápido (4 páginas), Manual do utilizador (22 páginas), Manual de início rápido (4 páginas), Manual de instalação (39 páginas), Manual de início rápido (2 páginas), Manual de início rápido (2 páginas), Manual de início rápido (2 páginas)

Hardware Installation

• Red, solid—Network connection resetting.

Use this procedure to check that the base station and the network can communicate with each other, before

you mount the base station in the chosen location.

Before you begin

The base station requires:

• Power over Ethernet (PoE) or a power adapter

• LAN connection

• An IP address assigned by DHCP in the network

Procedure

Step 1

Plug one end of the Ethernet cable into the base station.

Step 2

Plug the other end of the Ethernet cable into the LAN port.

Step 3

If you don't use PoE, plug the power adapter into the base station and then into the electrical outlet.

Step 4

If the LED flashes red after a few minutes, do these steps:

a) Locate the Reset button on the bottom edge of the base station.

b) Press and hold Reset until the LED is a solid red.

c) Release Reset.

The LED should flash amber and then try to connect. If the LED doesn't light green, then the base station

can't get an IP address. See

What to do next

Mount the base station with one of these procedures:

•

Mount the Base Station or Repeater on the Ceiling

You can mount the base station or repeater on a ceiling. They use a custom ceiling mount bracket that you

can install on the ceiling. You need to order the ceiling mount bracket.

Base Station LED is Solid Red

Mount the Base Station or Repeater on the Ceiling, on page 7

Mount the Base Station or Repeater on a Desk, on page 11

Mount the Base Station or Repeater on the Wall, on page 12

Mount the Base Station or Repeater on the Ceiling

for further help.

Hardware Installation