Cisco 6945 Series 사용자 설명서 - 페이지 3

{카테고리_이름} Cisco 6945 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6945 Series 10 페이지. 6900 series
Cisco 6945 Series에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 빠른 참조 (2 페이지), 릴리스 정보 (18 페이지), 사용자 설명서 (38 페이지), 사용자 설명서 (8 페이지), 관리 매뉴얼 (14 페이지), 설정 매뉴얼 (16 페이지), 특징 (29 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 설치 및 사용자 설명서 (12 페이지), 빠른 참조 사용 설명서 (2 페이지), 매뉴얼 (2 페이지), 지침 (3 페이지), 빠른 시작 매뉴얼 (2 페이지), 기능 설명서 (4 페이지), 사용자 설명서 (34 페이지), 빠른 설치 매뉴얼 (12 페이지), 빠른 참조 매뉴얼 (2 페이지)

Cisco 6945 Phone and Voicemail User Guide

To Transfer a Call...

o Press the Transfer button on your phone, dial the number to transfer to, then...



o Before it is answered



o After it is answered



o Press the Transfer button

o Press the star/asterisk button (*)

o Key in the person's extension

o Press the Transfer button again to complete the transfer

The conferencing limit is sixteen phones. However, for group calls with four or more participants, we

recommend using the "Meet Me" style conference call (please see below). For traditional conference

calling:

o Call the first person from your desk phone

o Press the "Conference" button. This will put the original person on hold, and will meanwhile

create a new dial tone for you.

o Dial the next number that you would like to conference in

o Press the "Conference" button again

o This will take the original person off from "Hold," and will join all three parties together

o Repeat this process to add additional parties

For "Meet-Me" Conference Calling...

o Please refer to instructions under the "New Stuff" section on page 5

To Forward Your Calls... (limited to campus and local numbers only)

o Press the Fwd All softkey at the bottom of the screen and enter the desired number

Revised 1/30/2013

Wheaton College

Press the Transfer button again to release the call, or

Wait on the line until someone answers or the call goes to voicemail

Press the "Swap" softkey to move between the two calls

Press the Transfer button to release the call

Press the "Cancel" softkey and then the "Resume" softkey to reconnect to the original

caller

Press the "End Call" softkey and then the Resume softkey to reconnect to the original

caller

Page 3