Digital Guard Dawg Watch Dawg-X2 기능 및 작동 지침 - 페이지 4
{카테고리_이름} Digital Guard Dawg Watch Dawg-X2에 대한 기능 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Guard Dawg Watch Dawg-X2 6 페이지.
페이지 인쇄 Key Switch Reminder
If the alarm is disarmed and not started within 25 seconds the transmitter will beep and vibrate
reminding you to take the key out of the ignition switch.
LED warning
When the System has been armed the LED will flash twice every 2 seconds. While the system is armed, if
the motion sensor is triggered (stage 1) the LED with flash 4 times every 2 seconds. When the alarm is
fully triggered the LED will flash the entire duration of the alarm.
Motion Sensor
The motion sensor, is an adjustable 2 stage sensor. The sensitivity can be adjusted by rotating the dial
on the side of the alarm unit. If the motion sensor is triggered, the first time it will trigger a few short
beeps from the siren and a few flashes from the turn signals. If the motion sensor is triggered again
within 15 seconds it will trigger the system to fully alarm.
Out of Range Warning
When the alarm has been set and the remote has not had contact with the alarm for 3 minutes the
range indicator on the remote will no longer be lit up.
Transmitter Battery Indicator