Siemens ZIC-4A 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Siemens ZIC-4A에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens ZIC-4A 24 페이지. Zone indicating card

PRE-INSTALLATION

Siemens Industry, Inc.

Building Technologies Division

TROUBLE

ZONE 3 ACTIVE

TROUBLE

ZONE 4 ACTIVE

TROUBLE

Three rotary dial switches at the bottom of the front panel are used to set the HNET

network address of the ZIC-4A.

The following components must be set prior to inserting the card to the CC-5 (refer

to Figure 2):

S1 Primary Bell Follower Select Switch:

This switch selects Zone 1 as the Primary

Bell Follower. Toggle the S1 switch

towards the bottom of the board if Zone

1 is configured as a Primary Bell Follower;

otherwise toggle it to the top of the

board for normal operation (as shown in

Figure 2.)

S2, Leased Line Select Switches: These

switches select the zones configured for

Leased Line application. Toggle each

switch to the ON position if the corre-

sponding zone is configured as Leased

Line. If the zone is not configured as a

Leased Line application, the correspond-

ing zone switch must be set to the OFF

position.

During card failure, Zone 1 and Zone 2

outputs will activate if the FireFinder-

XLS/Desigo Fire Safety Modular/Cerberus

PRO Modular Alarm bus is asserted,

Zone 3 outputs will activate the if the

FireFinder-XLS/Desigo Fire Safety

Modular/Cerberus PRO Modular Trouble

Bus is asserted. You must configure each

zone to the proper Leased Line remote

monitoring circuit.

Silver line on S1 and jumpers P1 and

P4 indicates normal operation.

(Yellow)