Siemens 3hb557xm 설치 지침 - 페이지 5

{카테고리_이름} Siemens 3hb557xm에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens 3hb557xm 5 페이지.

The oven must be connected taking into account the voltage

■

indicated on the oven's specifications plate.

To connect the appliance it should be positioned in front of

■

the unit. The connection cable should be long enough to

ensure connection.

Warning! Make sure the connection cable does not become

trapped during installation and that it does not come into

contact with the hot parts of the oven.

Any handling of the appliance, including changing or installing

■

the power cable, must be performed by the Technical

Assistance Service.

Positioning the oven in the unit: figure 4

For ovens with a pull-out carriage door, the door must be

■

removed.

Push the oven completely into the space in the unit provided

■

for this purpose. Make sure the cable has not been stripped

by the oven edges, that it is not in contact with hot parts and

that it does not run along the bottom of the oven.

Centre the oven in the unit and fasten with the screws (4x25)

■

supplied.

If the unit has been built according to the measurements

■

provided, there will be a gap at the top of the oven. Do not

cover this gap with wooden slats so as to allow sufficient

ventilation.

There should be at least a 5 mm gap between the appliance

■

and the adjacent units (located beside the oven).

Dismantling

Disconnect the oven from the mains. Loosen the screws that

fasten the oven to the unit. Lift the oven slightly and remove it

completely from the unit.