Siemens 3hb557xm Instrukcje instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Piekarnik Siemens 3hb557xm. Siemens 3hb557xm 5 stron.

Siemens 3hb557xm Instrukcje instalacji
The oven must be connected taking into account the voltage
indicated on the oven's specifications plate.
To connect the appliance it should be positioned in front of
the unit. The connection cable should be long enough to
ensure connection.
Warning! Make sure the connection cable does not become
trapped during installation and that it does not come into
contact with the hot parts of the oven.
Any handling of the appliance, including changing or installing
the power cable, must be performed by the Technical
Assistance Service.
Positioning the oven in the unit: figure 4
For ovens with a pull-out carriage door, the door must be
removed.
Push the oven completely into the space in the unit provided
for this purpose. Make sure the cable has not been stripped
by the oven edges, that it is not in contact with hot parts and
that it does not run along the bottom of the oven.
Centre the oven in the unit and fasten with the screws (4x25)
supplied.
If the unit has been built according to the measurements
provided, there will be a gap at the top of the oven. Do not
cover this gap with wooden slats so as to allow sufficient
ventilation.
There should be at least a 5 mm gap between the appliance
and the adjacent units (located beside the oven).
Dismantling
Disconnect the oven from the mains. Loosen the screws that
fasten the oven to the unit. Lift the oven slightly and remove it
completely from the unit.