Siemens avantGarde SKU HB30D50U 설치 매뉴얼 - 페이지 6
{카테고리_이름} Siemens avantGarde SKU HB30D50U에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens avantGarde SKU HB30D50U 21 페이지. Built-in ovens
Siemens avantGarde SKU HB30D50U에 대해서도 마찬가지입니다: 기능 및 이점 (1 페이지)
페이지 인쇄
4. Connect Electric
Verify that electric to the junction box has been turned
off before beginning this step.
General Instructions:
•
Use copper wire ONLY. Wire size and connections
must be suitable for the rating of the appliance per
the National Electrical Code requirements or the
Canadian Electric Code requirements.
•
The fl exible conduit extending from the oven
should be connected directly to the junction box.
•
Do not shorten fl exible conduit.
•
The junction box should be located to allow as
much slack as possible between the junction box
and the oven.
•
A UL listed conduit connector must be provided at
each end of the power supply cable.
•
The four wire branch circuit connection is
preferred, but where local codes permit, a three
wire branch circuit connection is also acceptable.
Four Wire Connection (Preferred Method):
1. Connect green ground wire from oven to green (or
bare) ground wire in junction box.
2. Connect red wire from oven to red wire in junction
box.
3. Connect black wire from oven to black wire in
junction box.
4. Connect white wire from oven to white (or gray)
neutral wire in junction box.
Three Wire Connection :
Note: The four wire connection is preferred, but
where local codes permit, the three wire connection is
also acceptable.
1. Connect red wire from oven to red wire in junction
box.
2. Connect black wire from oven to black wire in
junction box.
3. Connect both green ground wire and white wire
from oven to white (or gray) neutral wire in
junction box.
Connecting to a 208 V circuit:
The oven is pre-wired for connection to 240 V, 60 Hz supply,
but can be converted for use with 208 V, 60 Hz supply.
1. Turn power on a breaker.
2. Open oven door (upper oven in double ovens)
3. Press CANCEL.
4. Turn knob clockwise until 6 double beeps sound.
4. Turn knob counterclockwise until 9 double beeps
sound.
5. Press START.
6. Press COOKING MODE.
7.
Press START.
Time of day clock appears in display.
Step 4: Connect Electric
Figure 4: Four Wire Connection
Figure 5: Three Wire Connection