Cisco 7926G 설치 매뉴얼 - 페이지 16

{카테고리_이름} Cisco 7926G에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7926G 21 페이지. Wavelink avalanche management console
Cisco 7926G에 대해서도 마찬가지입니다: 릴리스 정보 (16 페이지), 액세서리 매뉴얼 (20 페이지), 관리 매뉴얼 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 관리 매뉴얼 (23 페이지), 설치 매뉴얼 (12 페이지), 관리 매뉴얼 (14 페이지)

Headset Usage

headset automatically reconnects. For certain phone types that operate in power-save modes, the user may

have to "wake up" the headset by tapping on its operational button to initiate the reconnect.

Users should read the headset user guide for more information about pairing and connecting the headsets.

Note

Audio Quality

Beyond the physical, mechanical, and technical performance, the audio portion of a headset must sound good

to you (the user) and to the party on the far end. Sound is subjective and Cisco cannot guarantee the performance

of any headsets, but some of the headsets on the sites listed below have been reported to perform well on

Cisco Unified IP Phones.

Nevertheless, it is ultimately the customer's responsibility to test this equipment in their own environment to

determine suitable performance.

For information about wired and Bluetooth wireless headsets for your phone, see the Cisco Unified Wireless

IP Phone 7925G, 7925G-EX, and 7926G Accessory Guide and these web sites:

•

http://www.plantronics.com

•

http://www.jabra.com

•

http://www.jawbone.com

Cisco recommends the use of good quality external devices, such as speakers, microphones, and headsets that

are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.

Depending on the quality of these devices and their proximity to other devices, such as mobile phones or

two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or

more of the following actions:

• Move the external device away from the source of the RF or AF signals.

• Route the external device cables away from the source of the RF or AF signals.

• Use shielded cables for the external device, or use cables with a better shield and connector.

• Shorten the length of the external device cable.

• Apply ferrites or other such devices on the cables for the external device.

Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external

devices, cables, and connectors. The system performs adequately when suitable devices are attached with

good quality cables and connectors.

Caution

In European Union countries, use only external headsets that are fully compliant with the EMC Directive

[89/336/EC].

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup