Cisco 7926G 설치 매뉴얼 - 페이지 18
{카테고리_이름} Cisco 7926G에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7926G 21 페이지. Wavelink avalanche management console
Cisco 7926G에 대해서도 마찬가지입니다: 릴리스 정보 (16 페이지), 액세서리 매뉴얼 (20 페이지), 관리 매뉴얼 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 관리 매뉴얼 (23 페이지), 설치 매뉴얼 (12 페이지), 관리 매뉴얼 (14 페이지)
페이지 인쇄
Active and Standby Phone Modes
Active and Standby Phone Modes
The following sections describe the available modes when the Cisco Unified Wireless IP Phone is powered
on.
Active Mode
The phone is in active mode when there is an active RTP stream. When the phone is performing one of these
actions, it is consuming power:
• Connected to an active call
• Scanning for channels
• Sending CDP packets
• Sending keepalive messages
• Reregistering with Cisco Unified Communications Manager
Related Topics
Phone Power, on page 8
Standby Mode
The phone can enter standby mode if none of the events from the Active Mode list are currently active. The
phone awakes from standby mode in response to these events:
• Pressing keys on the keypad
• Roaming between APs
• Power cycling the phone
• Losing network connectivity
• Losing RF connectivity
• Transmitting scheduled CDP or keepalive packets
Related Topics
Phone Startup Process, on page 18
Startup and Connectivity Problems
Phone Startup Process
When connecting to the wireless VoIP network, the Cisco Unified Wireless IP Phone goes through a standard
startup process, as described in the following list. Depending on your specific network configuration, not all
of these steps may occur on your wireless IP phone.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
18
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup