Cisco 7926G 관리 매뉴얼 - 페이지 12
{카테고리_이름} Cisco 7926G에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7926G 14 페이지. Wavelink avalanche management console
Cisco 7926G에 대해서도 마찬가지입니다: 릴리스 정보 (16 페이지), 액세서리 매뉴얼 (20 페이지), 관리 매뉴얼 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 관리 매뉴얼 (23 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (21 페이지)
페이지 인쇄
Wavelink Settings Fields
Item
Network Services Level
Security Level
User Interface Level
Wireless Level
Audio Level
System Level
Wavelink Settings Fields
You can configure Wavelink settings from the phone CU. The following table describes the Wavelink settings.
Table 4: Wavelink settings
Setting
Enable
Use Alternate Server
Alternate Server
Custom Name 1-4
Custom Value 1-4
Update Phone
When you have completed the phone configuration changes, you must export the configuration file from the
phone CU to Wavelink, and then update the phone.
Note
The CU does not perform a complete validation of the phone configuration. If the configuration file
contains an invalid setting, the phone may reject the configuration and send an error message to the syslog.
To update the phone with the updated configuration file, perform the following steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
12
Description
DHCP, TFTP, CDP data.
Application level security data.
Key strokes, softkeys, MMI data.
Channel scanning, authentication data.
RTP, SRTP, RTCP, DSP data.
Firmware, upgrade data.
Description
Enables the Wavelink server.
Enables the use of alternate Wavelink server.
If the User Alternate Server is enabled, enter an IP address for the alternate
server.
Assign up to four attribute names to the phone to be used as selection
criteria.
Define the values for each Custom Name to be used as selection criteria.
Wavelink Avalanche Server