Mount Phone on Wall
Mount Phone on Wall
You can mount the Cisco Unified IP Phone on the wall using special brackets that are available in a
Cisco Unified IP Phone wall mount kit. Wall mount kits must be ordered separately from the phones.
You can also attach the phone to the will without a wall mount kit. In either case, you need the following tools
and parts:
• Screwdriver
• Screws to secure the Cisco Unified IP Phone to the wall (included with the wall mount kit
Before You Begin
To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook from
the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip on which
the handset catches when the phone is vertical. For an illustrated procedure, refer to Installing the Universal
Wall Mount Kit for the Cisco Unified IP Phone at
prod_installation_guides_list.html.
To mount the phone on the wall without using the wall mount kit, follow these steps:
Use care to not damage wires or pipes located inside the wall when securing screws to wall studs.
Caution
Procedure
Step 1
Remove the footstand if it is attached to the phone.
To remove the footstand, disengage the footstand tabs from the phone by grasping and gently squeezing the
footstand at the top and bottom, near where the stand attaches to the phone.
Step 2
Insert two screws into a wall stud, matching them to the two screw holes on the back of the phone.
The holes fit standard phone jack mounts.
Step 3
Hang the phone on the wall.
Phone Startup Verification
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling
through these steps.
1 These buttons flash on and off in sequence:
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP
and SIP)
8
• Mute
• Speaker
• Line 1 (amber)
Cisco Unified IP Phone Installation
http://www.cisco.com/en/US/products/hw/phones/ps379/
페이지 인쇄