Cisco 7931G - Unified IP Phone VoIP Podręcznik administracyjny - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik administracyjny dla Telefon IP Cisco 7931G - Unified IP Phone VoIP. Cisco 7931G - Unified IP Phone VoIP 12 stron. For cisco unified callmanager express 4.0
Również dla Cisco 7931G - Unified IP Phone VoIP: Podręcznik użytkownika (20 strony), Podręcznik administracyjny (10 strony), Podręcznik administracyjny (17 strony), Podręcznik administracyjny (20 strony), Instrukcje instalacji (4 strony), Podręcznik (30 strony), Skrócona instrukcja obsługi (2 strony), Skrócona karta informacyjna (2 strony), Podręcznik użytkownika (15 strony)

Mount Phone on Wall

You can mount the Cisco Unified IP Phone on the wall using special brackets that are available in a

Cisco Unified IP Phone wall mount kit. Wall mount kits must be ordered separately from the phones.

You can also attach the phone to the will without a wall mount kit. In either case, you need the following tools

and parts:

• Screwdriver

• Screws to secure the Cisco Unified IP Phone to the wall (included with the wall mount kit

Before You Begin

To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook from

the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip on which

the handset catches when the phone is vertical. For an illustrated procedure, refer to Installing the Universal

Wall Mount Kit for the Cisco Unified IP Phone at

prod_installation_guides_list.html.

To mount the phone on the wall without using the wall mount kit, follow these steps:

Use care to not damage wires or pipes located inside the wall when securing screws to wall studs.

Caution

Procedure

Step 1

Remove the footstand if it is attached to the phone.

To remove the footstand, disengage the footstand tabs from the phone by grasping and gently squeezing the

footstand at the top and bottom, near where the stand attaches to the phone.

Step 2

Insert two screws into a wall stud, matching them to the two screw holes on the back of the phone.

The holes fit standard phone jack mounts.

Step 3

Hang the phone on the wall.

After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling

through these steps.

1 These buttons flash on and off in sequence:

Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP

and SIP)

• Mute

• Speaker

• Line 1 (amber)

Cisco Unified IP Phone Installation

http://www.cisco.com/en/US/products/hw/phones/ps379/