Cisco 7940G 매뉴얼 - 페이지 22

{카테고리_이름} Cisco 7940G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7940G 35 페이지. Ios telephony services ip phone
Cisco 7940G에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (25 페이지), 데이터시트 (7 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (15 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (20 페이지), 전화 매뉴얼 (17 페이지), 관리자 매뉴얼 (15 페이지), 사용자 설명서 (16 페이지), 참조 매뉴얼 (24 페이지), 관리 매뉴얼 (29 페이지), 매뉴얼 (21 페이지), 설치 매뉴얼 (12 페이지), 사용자 설명서 (10 페이지)

5.2. Configure the Avaya Converged Communications Server

5.2.1. Adding an Address Map

Address maps are used in the Converged Communications Server to specify how incoming SIP

calls are to be routed, based on the dialed number. They are grouped by the SIP contact to which

they will be routed. For host maps, specified in the Hosts link, the SIP contact must be specified

completely. To configure support for the Outboard Proxy SIP features supported by

Communication Manager on an Avaya Media Server, Media Server maps are defined using the

Media Servers link. In this case, the contact information is automatically generated and dialed

numbers matching the map specification cause the call to be routed to the associated Media

Server. In this configuration, any number the user may dial, including the FNEs defined in

Section 5.1, must be covered by the map specification, so that these calls (i.e. SIP INVITE

messages) will be routed to the S8300/G700, where Communication Manager will route the call

based on its dial plan. This means that the map specification(s) must agree with the dial plan

administered in Communication Manager.

Note: To route toll calls back through the Converged Communications Server and on to a SIP

service provider, configure Communication Manager such that the number sent to Converged

Communications Server on the SIP trunk is not identical to that dialed by the user. Otherwise

the Converged Communications Server will route the call back to Communication Manager and

a loop will result. For example, to dial outbound numbers, the user may have to dial "9"

followed by the area code and number. A media server map in the Converged Communications

Server would match on the initial 9 and route the call to Communication Manager.

Communication Manager would in turn route the call back to the Converged Communications

Server using a modified form of the number that would match a Converged Communications

Server address map for outbound routing to the service provider.

The following steps describe how to administer the Media Server Map. See Reference [1] for

more information on the syntax used to specify address maps.

FAS; Reviewed:

WCH 10/22/2004

Solution & Interoperability Test Lab Application Notes

22 of 35

Cisco7960SIP.doc