Cisco 7940G 관리 매뉴얼 - 페이지 16

{카테고리_이름} Cisco 7940G에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7940G 29 페이지. Ios telephony services ip phone
Cisco 7940G에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (25 페이지), 데이터시트 (7 페이지), 매뉴얼 (35 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (15 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (20 페이지), 전화 매뉴얼 (17 페이지), 관리자 매뉴얼 (15 페이지), 사용자 설명서 (16 페이지), 참조 매뉴얼 (24 페이지), 매뉴얼 (21 페이지), 설치 매뉴얼 (12 페이지), 사용자 설명서 (10 페이지)

페이지 인쇄

Configuring the SIP Parameters Manually

To set a required parameter, select it and set it as desired. The following are required parameters that you

must set now if you did not set them in the default configuration file as described in the

Customize the Default Configuration File" section on page

line1_name—Number or e-mail address for use when registering. Enter a number without dashes.

•

For example, enter 555-0100 as 5550100. Enter an e-mail ID without the host name.

proxy1_address—IP address of the SIP proxy server that is used by the phones. Enter the address in

•

IP dotted-decimal notation or use the FQDN. The "x" argument is representative of server addresses.

If the parameter is provisioned with an FQDN, the phone sends REGISTER and INVITE messages

by using the FQDN in the Req-URI, To, and From fields.

proxy1_port—Port number of the SIP proxy server that is used by line 1.

•

If the proxy server with which the phone communicates has authentication enabled, set the following

•

parameters as well:

–

Step 4

Set additional parameters as needed.

To set a parameter, select it and set it as desired. Phone-specific parameters are listed in

Select Save.

Step 5

The phone programs the new information into flash memory and resets.

To restore parameters to default values, follow these steps:

Procedure

Unlock the phone.

Step 1

See the

Select Settings > SIP Configuration.

Step 2

The SIP Configuration menu appears.

Highlight the parameter whose setting you want to restore

Step 3

Step 4

Select Edit followed by <--.

Step 5

Select Accept.

Step 6

If necessary, select Back to exit the menu.

Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)

3-16

line1_authname—Name used by the phone for authentication if a registration is challenged by

the proxy server during initialization. Default is UNPROVISIONED.

line1_password—Password used by the phone for authentication if a registration is challenged

by the proxy server during initialization. Default is UNPROVISIONED.

"Unlocking the Phone" section on page

Chapter 3

Initializing Cisco Unified IP Phones

3-4:

3-10.

"How to

Table

3-3.

OL-7890-01