Siemens SITRANS LVL200E 사용 설명서 - 페이지 19

{카테고리_이름} Siemens SITRANS LVL200E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS LVL200E 44 페이지. Vibrating switches
Siemens SITRANS LVL200E에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (16 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

Housing overview

MAN-100411

2. Loosen compression nut of the cable gland and remove blind

plug

3. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.

1 cm (0.4 in) of insulation from the ends of the individual wires

4. Insert the cable into the sensor through the cable entry

5. Open the terminals with a screwdriver

6. Insert the wire ends into the open terminals according to the wir-

ing plan

7. Tighten the terminals with a screwdriver

8. Check the hold of the wires in the terminals by lightly pulling on

them

9. Tighten the compression nut of the cable entry gland. The seal

ring must completely encircle the cable

10. Screw the housing lid back on

The electrical connection is finished.

5.3

Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the Ex-d

version.

Fig. 10: Material versions, single chamber housing

Plastic (not with Ex d)

Aluminium

Stainless steel (not with Ex d)

Stainless steel, electropolished (not with Ex d)

Filter element for pressure compensation or blind plug with version IP 66/

IP 68, 1 bar (not with Ex d)

SITRANS LVL200E - Operating Instructions