Siemens SITRANS RD500 사용 설명서 - 페이지 10

{카테고리_이름} Siemens SITRANS RD500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS RD500 48 페이지. Configuring sitrans rd500 for connection to multiranger with modbus rtu
Siemens SITRANS RD500에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 애플리케이션 매뉴얼 (6 페이지), 매뉴얼 (11 페이지), 적용 사례 (9 페이지)

Siemens SITRANS RD500 사용 설명서
Using with Mozilla Firefox
Please note that setup option locations and settings may vary among versions.
1.
Open your browser.
2.
Click Tools and select Options.
3.
Click the Privacy tab and then click the Cookies tab.
4.
Check Allow site to set Cookies.
5.
Click OK to save your new settings and close the Options box.
Connection
On the instruction manual CD included with the product, you will find the
Note:
RD500 USB Windows-based configuration application. This application can be
used by connecting your PC to the RD500 with a USB type A to B cable. The RD500
USB application allows for firmware updates, resetting of the password, setting
the IP address, and resetting the RD500 to factory defaults.
This utility is also available on our website at
www.siemens.com/sitransRD500 under Downloads.
For initial setup, connect to the RD500 via an Ethernet crossover cable. This will allow a
point-to-point connection to your PC for the purpose of configuration and application
testing.
The RD500's default IP address is 192.168.2.100. For a simple network, the first three
octets of your PC's IP address must match the RD500's. Therefore, a suitable IP for your
PC would be 192.168.2.10.
The crossover Ethernet cable is used for a point-to-point network, while a
Note:
standard straight-through Ethernet cable is used in most LAN or WAN networks.
Straight-through Ethernet cable can be used for direct connection if PC or laptop
supports auto crossover detection.
Page 8
SITRANS RD500 – OPERATING INSTRUCTIONS
7ML19985MA01