Siemens SK Series 작동 지침 - 페이지 25
{카테고리_이름} Siemens SK Series에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SK Series 36 페이지.
Fault
A different error code is
indicated on the digital
display.
( :
to :
)
Display flashes.
Refill indicator for salt X
and/or rinse-aid P is lit.
Refill indicator for salt X
and/or rinse-aid P
is not lit.
Water is left
in the appliance at the end
of the programme.
Cause
A technical fault has probably
occurred.
Door not closed properly.
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under
the filters 1* is blocked.
The programme has not yet
ended.
Fault, what to do?
Remedial action
Switch off appliances with the ON/OFF
switch (. After a short time restart
the appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
Check refill indicator, levels.
Clean filters and area underneath (see
Waste water pump).
Wait until programme ends or reset (see
Terminating the programme).
en
25