Epson BrightLink Pro 1430Wi 설치 매뉴얼 - 페이지 22
{카테고리_이름} Epson BrightLink Pro 1430Wi에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson BrightLink Pro 1430Wi 26 페이지. Control pad and touch unit
Epson BrightLink Pro 1430Wi에 대해서도 마찬가지입니다: 시작하기 (6 페이지)
페이지 인쇄5 Installing the Control Pad
You must install the control pad on the same surface as the projector, within the range specified in the
installation instructions. You can use batteries to power the control pad, or the optional remote control cable
set (model ELPKC28, part number V12H005C28).
You must have completed the steps in "Installing the Projector" in the Installation Guide before installing the
Control Pad.
Follow the steps below to install the Control Pad and connect to the projector.
Caution
The Control Pad should only be connected to the BrightLink Pro 1420Wi/1430Wi. Do not
connect the Control Pad to any other projectors.
Check the installation location
The Control Pad must be installed in the area specified in the diagram below.
13.8 in.
35.4 in.
27.6 in.
78.7 in.
68.9 in.
(0.7 m)
(0.35 m)
(0.9 m)
(2.0 m)
(1.75 m)
Make sure there is enough space surrounding the Control Pad. Because the top panel
opens from the left, there must be additional space to the left of the Control Pad.
9.8 in.
(0.25 m)
60-inch
image
100-inch
image
39.3 in. (1.0 m)
59.0 in. (1.5 m)
78.7 in. (2.0 m)
2 in. (50 mm)
3.9 in
(100 mm)
2 in. (50 mm)
Remote control
light emitting areas
2 in
(50 mm)