Cisco 8831 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 8831에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 8831 13 페이지. Hard factory reset
Cisco 8831에 대해서도 마찬가지입니다: 특징 (17 페이지), 설치 매뉴얼 (14 페이지), 배포 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (6 페이지), 빠른 참조 매뉴얼 (6 페이지), 사용자 설명서 (15 페이지), 빠른 참조 매뉴얼 (2 페이지), 문제 해결 매뉴얼 (3 페이지)

Use these procedures to install the phone and connect it to your network.

Turn the Sound Base over to expose the ports on the back of the unit.

Step 1

Connect the Display Control Unit (DCU) to the Sound Base.

Step 2

If you are using an external microphone, connect it to one of the microphone jacks.

Step 3

Note

You can connect 2 wired microphones to the Sound Base.

Step 4

If you are using an external power source, insert one end of the power cord into an outlet and insert the

other end of the power cord into the power port on the Sound Base.

Step 5

Connect your phone to the network:

•

Using an Ethernet Connection—Insert one end of the Ethernet cable into the network port on

the phone body marked "SW." Insert the other end of the Ethernet cable into the appropriate

device, such as a network switch, on your network.

•

Using a Wireless Connection—You can use a Cisco WBPN Wireless-N Bridge with the IP

phone to create a wireless connection between the phone and the network. See the WBPN

documentation on Cisco.com for more information. The

contains links to the documentation area on Cisco.com.

If you are using 2 Sound Bases, they should be daisy chained. (Connect the daisy chain cable to the daisy

Step 6

chain cable port in the Sound Bases.)

The DCU should be connected only to the master unit (Sound Base with wall power, DCU, and

Note

network cable) of a daisy chain.

Install the Cisco Unified IP Conference Phone 8831 for Third-Party Call Control

Cisco Unified IP Conference Phone 8831 for Third-Party Call Control Quick Start Guide

"Related Documentation"

section