Cisco 8832 매뉴얼 - 페이지 11

{카테고리_이름} Cisco 8832에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 8832 30 페이지. Masergy ip conference phone
Cisco 8832에 대해서도 마찬가지입니다: 펌웨어 마이그레이션 마스터 매뉴얼 (31 페이지), 사용자 설명서 (20 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (30 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (16 페이지), 유지 관리 매뉴얼 (9 페이지), 빠른 시작 (2 페이지), 설정 (14 페이지), 빠른 시작 매뉴얼 (2 페이지), 재구성 매뉴얼 (2 페이지), 빠른 시작 (2 페이지)

페이지 인쇄
Cisco 8832 매뉴얼
Your Phone
Step 2
Extend the microphone cable to the desired position.
The following figure shows installation of a wired expansion microphone.
Figure 4: Wired Expansion Microphone Installation
Related Topics
Install the Wireless Expansion Microphones
The conference phone provides the option of connecting two wireless expansion microphones.
Note
When the phone is in a call, the LED on the expansion microphone is lit green. To mute the expansion
microphone, press the Mute key. When the microphone is muted, the LED is lit red. When the battery in the
microphone is low, the battery indication LED blinks rapidly.
Before you begin
Disconnect the wired expansion microphones before you install wireless expansion microphones. You cannot
use both wired and wireless expansion microphones at the same time.
Procedure
Step 1
Position the table mount plate on the table surface location where you want to place the microphone.
Step 2
Remove the adhesive for the double-stick tape on the bottom of the table mount plate. Place the table mount
plate to adhere to the table surface.
Wired Expansion Microphone (8832
You must use either two wired microphones or two wireless microphones with the phone, but not a mixed
combination.
Install the Wireless Expansion Microphones
0nly), on page 20
Your Phone
11