Epson EB-475Wi 설치 매뉴얼 - 페이지 18

{카테고리_이름} Epson EB-475Wi에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EB-475Wi 37 페이지. Ultra-short-throw interactive projectors
Epson EB-475Wi에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (6 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Epson EB-475Wi 설치 매뉴얼

5. Installation Procedure

Make sure to follow the steps below to install the setting plate. If you ignore these steps, the setting plate
could fall and cause personal injury or property damage.
Warning
❏
When you mount the projector on the wall with the setting plate, the wall requires enough
strength to hold the projector and the setting plate.
This setting plate should be installed on a concrete wall. Confirm the weight of the
projector and the setting plate before installation, and maintain the strength of the wall. If
the wall is not strong enough, reinforce the wall before installation.
❏
The combined mass of the projector and the setting plate is 14.5 kg.
❏
Do not hang the rest of the cable over the setting plate.
❏
Install the setting plate so that it can sufficiently support the mass of the projector and
setting plate, and resist any horizontal vibration. Use M8 nuts and bolts. Nuts and bolts
smaller than M8 could cause the setting plate to fall.
❏
Epson accepts no responsibility for any damage or injury caused by lack of wall strength or
inadequate installation.
a

Disassemble the parts

Remove the slide plate from the 3-axis adjustment unit.
• Remove the M4 x 12 mm hexagon socket head cap bolts (x2) (
• Remove the slide plate from the 3-axis adjustment unit (
M4 x 12 mm hexagon
socket head cap bolts
(x2)
b
Assemble the parts
(1) Assemble the wall plate.
Assemble the three plates into one unit, and secure them with the M4 x 12 mm hexagon socket head
cap bolts (x6) supplied.
M4 x 12 mm hexagon socket head cap bolts
Washer
Spring washer
).
).
18
Slide plate