Epson EB-475Wi Руководство по установке - Страница 18

Просмотреть онлайн или скачать pdf Руководство по установке для Проектор Epson EB-475Wi. Epson EB-475Wi 37 страниц. Ultra-short-throw interactive projectors
Также для Epson EB-475Wi: Технические характеристики (2 страниц), Технические характеристики (6 страниц), Краткое руководство по эксплуатации (2 страниц)

5. Installation Procedure

Make sure to follow the steps below to install the setting plate. If you ignore these steps, the setting plate

could fall and cause personal injury or property damage.

Warning

❏

When you mount the projector on the wall with the setting plate, the wall requires enough

strength to hold the projector and the setting plate.

This setting plate should be installed on a concrete wall. Confirm the weight of the

projector and the setting plate before installation, and maintain the strength of the wall. If

the wall is not strong enough, reinforce the wall before installation.

❏

The combined mass of the projector and the setting plate is 14.5 kg.

❏

Do not hang the rest of the cable over the setting plate.

❏

Install the setting plate so that it can sufficiently support the mass of the projector and

setting plate, and resist any horizontal vibration. Use M8 nuts and bolts. Nuts and bolts

smaller than M8 could cause the setting plate to fall.

❏

Epson accepts no responsibility for any damage or injury caused by lack of wall strength or

inadequate installation.

Remove the slide plate from the 3-axis adjustment unit.

• Remove the M4 x 12 mm hexagon socket head cap bolts (x2) (

• Remove the slide plate from the 3-axis adjustment unit (

M4 x 12 mm hexagon

socket head cap bolts

(x2)

Assemble the parts

(1) Assemble the wall plate.

Assemble the three plates into one unit, and secure them with the M4 x 12 mm hexagon socket head

cap bolts (x6) supplied.

M4 x 12 mm hexagon socket head cap bolts

Washer

Spring washer

Slide plate