Cisco Aironet 521 빠른 시작 매뉴얼 - 페이지 20

{카테고리_이름} Cisco Aironet 521에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 521 26 페이지. Ip phones with multiplatform firmware
Cisco Aironet 521에 대해서도 마찬가지입니다: 매뉴얼 (35 페이지), 사용자 설명서 (46 페이지), 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 설치 매뉴얼 (39 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

a521qsg.fmb Page 18 Monday, March 12, 2007 10:40 AM

D R A F T - C I S C O C O N F I D E N T I A L

Resetting to Default Configuration

If you forget your password that allows you to configure the access point, you

may need to completely reset the configuration. You can use the MODE

button on the access point to reset the configuration.

These steps reset all configuration settings to factory defaults,

Note

including passwords, WEP keys, the IP address, and the SSID.

Using the MODE Button

Follow these steps to delete the current configuration and return all access

point settings to the factory defaults by using the MODE button:

1. Open the access point cover (refer to the "How to Open the Top Cover"

section on page 2).

2. Disconnect power from the access point (the power jack for external

power or the Ethernet cable for in-line power).

3. Press and hold the MODE button while you reconnect power to the

access point.

4. Continue pressing the MODE button until the Ethernet LED turns

amber. (approximately 2 to 3 seconds). Then release the button.

78-18092-01