Cisco Cisco Headset 561 사용자 설명서 - 페이지 13

{카테고리_이름} Cisco Cisco Headset 561에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco Headset 561 46 페이지. Ip phones with multiplatform firmware
Cisco Cisco Headset 561에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (3 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 설치 매뉴얼 (39 페이지), 매뉴얼 (24 페이지), 빠른 참조 매뉴얼 (7 페이지)

Your Headset

Figure 4: Standard Base LEDs

The following table describes the standard base.

Table 7: Standard Base LEDs

Number

Cisco Headset 560 Series Multibase

The multibase can connect up to three call sources through Bluetooth, the USB connector, or the Y-cable.

You can switch between call sources using the button interface on the multibase. You can answer and end

calls by selecting the call control buttons on your headset, or by lifting and returning your headset to the base.

The multibase comes with the following connector cables:

Name

Battery Status LED

Call Status LED

Cisco Headset 560 Series Multibase

Description

Indicates the headset battery charge and base status:

• Headset battery strength—LEDs blink and change to

solid as the battery charges.

• Headset update in progress—LEDs blink in sequence,

left to right.

• Headset and base not paired—All LEDs blink

• Power save mode—Middle LED shows solid.

The base enters power save mode when there is no call source

connectivity after 10 minutes.

Alerts you to the call state:

• Incoming call—Blinking green

• Active call—Steady green

• Muted call—Steady red

Cisco Headset 500 Series User Guide