Ricoh Aficio AP4510 보충 설명서 - 페이지 10

{카테고리_이름} Ricoh Aficio AP4510에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio AP4510 38 페이지. Sap printing
Ricoh Aficio AP4510에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지), 교체 매뉴얼 (2 페이지), 설치 절차 (2 페이지), 설치 매뉴얼 (4 페이지), 매뉴얼 (12 페이지), 빠른 설치 매뉴얼 (2 페이지)

페이지 인쇄

UNIX Configuration

Deleting the printer

To print using the lp or lpr command, the option specified when the installation

shell script is executed is used. Change the option in accordance with the work-

station you are using.

❖ ❖ ❖ ❖ BSD UNIX workstation, Linux

Delete the printer entry from /etc/printcap, and then execute the installation

shell script again. Select options during the setup process.

Or, search the printer entry from /etc/printcap, and change its rp capability

to option setting.

❖ ❖ ❖ ❖ Solaris, HP-UX

Delete the printer entry, and then execute the installation shell script again.

Select options during the setup process. To delete the printer entry, follow the

procedure below.

Stop the scheduler.

# /usr/sbin/lpshut

Delete the printer.

# /usr/sbin/lpadmin -x printer_name

Restart the scheduler.

# /usr/lib/lpsched

After Executing Installation Shell Script

The printing environment is set up automatically when the installation shell

script is executed.

This section describes the set up contents when the installation shell script is ex-

ecuted under Red Hat Linux, Solaris and HP-UX.

Linux

❖ ❖ ❖ ❖ Adding the IP address and host name to the /etc/hosts file

The following line is added to the /etc/hosts file. The IP address and printer

host name which you previously entered in the installation script will be used.

192.168.15.16 nphost # Network Printer

• 192.168.15.16 is the IP address, nphost is the host name, from # to the end

of the line is a comment.

Note

❒ The /etc/hosts file contains a list of the IP addresses and host names of all

of the hosts communicating on the network. Each entry is delimited with

a space or a tab, and each line is separated with a return.

❒ If you do not use NIS or DNS, you must manually enter the IP address and host

name of each workstation using the network printer in the /etc/hosts file.