Ricoh Aficio CL3000e DOT 보충 설명서 - 페이지 11

{카테고리_이름} Ricoh Aficio CL3000e DOT에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio CL3000e DOT 38 페이지. Sap printing
Ricoh Aficio CL3000e DOT에 대해서도 마찬가지입니다: 사양 (2 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

E E E E

Enter the IP address of the printer.

Enter Printer host IP address <xxx.xxx.xxx.xxx> [re-

turn=skip]:

192.168.15.16

Note

❒ The IP address will be added to the /etc/hosts file.

❒ If the host name of the printer has already been configured, press the { { { { RE-

TURN} } } } key. Nothing will be added to the /etc/hosts file.

F F F F

Enter the host name of the printer.

Enter Printer host name : nphost

Note

❒ The host name will be added to the /etc/hosts file.

❒ If no IP address was entered in step

file.

G G G G

Configure the printer name.

Enter logical printer name [default nphost_prn]

If you want to use the default name, press the { { { { RETURN} } } } key. Enter a new

name, if you want to use a different one.

Note

❒ The host name entered in step

H H H H

Set the print option.

Enter remote printer name [default lp]:

• Press the { { { { RETURN} } } } key, and print with PCL or PostScript is enabled.

• If you want to set the device option, enter the option parameter.

Enter remote printer name [default lp]:tray=tray1

For more information about the device option, see p.19 "Specifying the De-

vice Option".

• If you enter "text", text printing is enabled.

If you enter "text", printing with PCL and PostScript is disabled.

Enter remote printer name [default lp]:text

Limitation

❒ You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red

Hat Linux 7.0, and 51 for Red Hat Linux 6.2.

❒ When printing with the lp command, use ( _ ) instead of ( = ) and ( ; ) in-

stead of ( , ) for operating systems that cannot use ( = ) and ( , ) such as So-

laris 2.5 or later.

After the installation shell script setup is complete, and if you enter the IP ad-

dress in step

, the following message appears.

hosts file is modified

, nothing is added to the /etc/hosts

followed by "_prn" appears in "default".

Using the Installation Shell Script