Cisco UNIFIED 6911 관리 매뉴얼 - 페이지 11

{카테고리_이름} Cisco UNIFIED 6911에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UNIFIED 6911 12 페이지. Telefone ip cisco unified
Cisco UNIFIED 6911에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 관리 매뉴얼 (10 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (50 페이지), 빠른 참조 카드 (2 페이지), 매뉴얼 (10 페이지), 매뉴얼 (28 페이지), (포르투갈어) 빠른 시작 (1 페이지)

Cisco Unified IP Phone and Telephony Networks

Cisco Unified IP Phones and Different Protocols

The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control Protocol) or SIP (Session Initiation

Protocol). You can convert a phone that is using one protocol to use the other protocol.

Convert New Phone from SCCP to SIP

A new, unused phone uses SCCP. To convert this phone to SIP, perform these steps:

Procedure

Step 1

Take one of these actions:

• To autoregister the phone, set the Auto Registration Phone Protocol parameter in Cisco Unified

• To provision the phone using the Bulk Administration Tool (BAT), choose the appropriate phone model

• To provision the phone manually, make the appropriate changes for SIP on the Phone configuration

Step 2

If you are not using DHCP in your network, configure the network parameters for the phone. See

Settings.

Step 3

To save the configuration updates,

a) Click Apply Config.

b) When the Apply Configuration Information window displays, click OK.

c) Tell the user to power cycle the phone.

In-Use Phone Protocol to Protocol Conversion

Phones using SCCP can be upgraded to use SIP. To change from SCCP to SIP, the phone firmware must be

updated to the recommended SIP version before the phones can register. New Cisco Unified IP Phones ship

from the factory with SCCP phone firmware. These new phones must be upgraded to the recommended SIP

version before they can complete registration.

For information about how to convert an in-use phone from one protocol to the other, see the Cisco Unified

Communications Manager Administration Guide, chapter "Cisco Unified IP Phone Configuration", section

"Migration Existing Phone Configuration to a Different Phone".

Communications Manager to SIP.

and choose SIP from the BAT.

For more information, see Cisco Unified Communications Manager Bulk Administration Guide.

window in Cisco Unified Communications Manager.

For more information, see Cisco Unified Commiunications Manager Administration Guide.

Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP

Cisco Unified IP Phones and Different Protocols

and SIP)

Network