Cisco UNIFIED 6911 6911 관리 매뉴얼 - 페이지 9
{카테고리_이름} Cisco UNIFIED 6911 6911에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UNIFIED 6911 6911 10 페이지.
Chapter 3
Setting Up the Cisco Unified IP Phone
Mounting the Phone to the Wall
You can mount the Cisco Unified IP Phone 6901 on the wall by using a standard telephone wall plate
with an opening for an RJ-45 connector. Cisco recommends that you use Leviton Wall Mount plate
(Leviton type number: 4108W-0SP) to wall mount the Cisco Unified IP Phone 6901. For information on
installing the wall mount kit for Cisco Unified IP Phone 6901, see
Mount for the Cisco Unified IP Phone 6901 and
You can mount the Cisco Unified IP Phone 6911 on the wall by using special brackets available in a
Cisco Unified IP Phone wall mount kit. For information on installing the wall mount kit, see
Appendix E, "Installing the Wall Mount for the Cisco Unified IP Phone 6901 and 6911"
"Cisco Unified IP Phone Non-Lockable Wall Mount."
Wall mount kits are not included with the phone and must be ordered separately.
Note
Verifying the Phone Startup Process
The LEDs on the MWI on the handset, and the LEDs on the Mute button light up during bootup. Upon
successful completion of the bootup process, the LEDs turn off, and the phone is ready for calls. If the
phone successfully boots up, it has started up properly. If the phone does not start up properly, the user
receives a reorder tone. For more information, see the
page
Configuring Startup Network Settings
If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
•
•
•
•
Collect this information and see the instructions in
Unified IP Phone."
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP)
OL-20852-01
7-1.
IP address
IP subnet information
Default Router
TFTP server IP address
Mounting the Phone to the Wall
Appendix E, "Installing the Wall
6911".
"Resolving Startup Problems" section on
Chapter 4, "Configuring Settings on the Cisco
or
Appendix F,
3-9