Ricoh Pro L5160 매뉴얼 - 페이지 9

{카테고리_이름} Ricoh Pro L5160에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Pro L5160 12 페이지. Additional function 2
Ricoh Pro L5160에 대해서도 마찬가지입니다: 추출 설정 매뉴얼 (44 페이지), 안전 정보 매뉴얼 (32 페이지), 빠른 시작 Quide (32 페이지)

페이지 인쇄

Added Alert Message of Intermittent Printing

⚫

When the alert message is displayed

Stop current printing once and review your network and RIP PC environment. In general,

check the following points. If the problem persists, contact your service representative.

If "100 Mbps" is selected as the "Ethernet Speed" setting in the "Network Settings" of

the printer, change the access speed to "Auto Selection" by following steps.

Press [User Tools] key on the control panel.

Press [Network Settings].

Press [Ethernet Speed].

Select [Auto Selection].

Check if your LAN is built with slower speed than the Gigabit Ethernet (GbE).

Check if your LAN cables, HUB, or network port of your PC supports GbE.

Check if your network device is operating on GbE mode.

Check if other devices are transmitting a large amount of data within the same LAN.

(e.g. Disconnect the printer and PC from your network once and connect them

directly peer-to-peer to see if the problem improves.)

Check if your RIP software is installed correctly. (e.g. The software is usually

installed on C drive. If the software is installed on the external drive, the performance

may be significantly reduced. Follow the notes in your RIP installation manual, etc.)

Check if your PC meets the recommended operating conditions of your RIP software

and if there is enough free space on the memory and/or HDD.