Cisco Unified 7905G 네트워크 설정 구성 - 페이지 18
{카테고리_이름} Cisco Unified 7905G에 대한 네트워크 설정 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Unified 7905G 34 페이지. Ip talk series
Cisco Unified 7905G에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 데이터시트 (5 페이지), 사용자 설명서 (25 페이지), 전화 매뉴얼 (46 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (20 페이지), 참조 매뉴얼 (20 페이지)
페이지 인쇄
Configuring IP Settings
Note
Assigning an IP Address
Step 2
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
4-18
You can use 0.0.0.0 for the subnet mask only if the default gateway is also
•
0.0.0.0.
Ensure the TFTP server has an IP address.
•
Ensure the default gateway IP address is on the same subnet as the host IP
•
address.
Procedures involved in configuring IP settings or TFTP options cannot be
completed when DHCP is enabled in your network.
This section covers the following topics:
Assigning an IP Address, page 4-18
•
•
Assigning a Default Router, page 4-19
Assigning a Subnet Mask, page 4-21
•
Assigning a Domain Name, page 4-22
•
Assigning DNS Servers, page 4-24
•
The IP address is the unique logical address identifying each host computer, or
node, on a TCP/IP network. An IP address is a 32-bit number expressed as four
decimal numbers from 0 to 255 separated by periods.
Before you can assign an IP address, you must disable DHCP. For instructions,
see the
"Disabling DHCP" section on page
To assign an IP address for the Cisco Unified IP Phone, follow these steps:
In the pane on the left under Change Configuration, click Network Parameters.
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
4-15.
4-2.
OL-8617-01