Ricoh SG Series 펌웨어 업데이트 - 페이지 3

{카테고리_이름} Ricoh SG Series에 대한 펌웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SG Series 16 페이지. Web image monitor
Ricoh SG Series에 대해서도 마찬가지입니다: 펌웨어 업데이트 (21 페이지)

페이지 인쇄

3. Update Cautions

This section describes several things you must check for to ensure successful up-

dates.

You must read this section before performing updates.

* For more details about cautions, refer to "ReadMe.txt".

Caution 1.

To update the firmware to version 2.0.0 or later, the current firmware must be version

1.9.0.

If the current firmware is earlier than version 1.9.0, update it first to version 1.9.0, and

then to version 2.0.0 or later.

To check the firmware version, print the configuration page.

[ /Menu]

[List/Test Print]

[Config. Page]

Caution 2.

Before performing updates, check your computer's power options: make sure [Put the

computer to sleep] is set to "Never".

To check your computer's Power Options under Windows 7 (procedures for other op-

erating systems will differ):

1. Click the [Start] menu.

2. Click [Control Panel].

3. Click [Hardware and Sound].

4. Click [Change when the computer sleeps].

5. Make sure [Put the computer to sleep] is set to "Never".

Caution 3.

During updates, make sure the machine's power is not turned off and the network or

USB cable remains connected. Also, during updates, do not print any jobs or run ap-

plications that use the printer driver, Status Monitor, or SmartDeviceMonitor.

Caution 4.

If the machine's power is turned off or the USB or network cable is disconnected during

updates, the update will fail and must be performed again.

Caution 5.

During updates, do not put the computer into [Put the computer to sleep] manually.