Ricoh SP 200 소프트웨어 설치 매뉴얼 - 페이지 11

{카테고리_이름} Ricoh SP 200에 대한 소프트웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SP 200 21 페이지. Software installation guide
Ricoh SP 200에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (2 페이지), 빠른 설치 매뉴얼 (2 페이지), 빠른 설치 매뉴얼 (2 페이지)

페이지 인쇄
Ricoh SP 200 소프트웨어 설치 매뉴얼
4.
From the CD-ROM menu, click [Network Quick Install (Fixed IP)].
5.
Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement.], and then click [Next >].
6.
Enter the MAC and IP addresses, and then click [OK].
To specify these in an IPv6 environment, click [Cancel], and then proceed to Step 8.
•
MAC address
Enter the MAC address shown on the network setting list.
•
IP address
Enter the user's IP address.
The computer's IP address can be ascertained using Command Prompt.
To display the IP address, open Command Prompt, enter "ipconfig", and then press the
[Enter] key.
Enter the IP address of the computer being used with the variable part in the IP address
modified.
•
Subnet mask, Default gateway address
Specify the subnet mask and default gateway address as required in accordance with the
network environment.
CTT190
CTT191
11