Ricoh 126C-FLEX TLS 매뉴얼 - 페이지 6

{카테고리_이름} Ricoh 126C-FLEX TLS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh 126C-FLEX TLS 7 페이지.

Flash pictures

Insert a 15-volt flash battery in Flash Battery Housing (P) according to the (+) ( - ) illustration in the Housing (Fig.

9).

Using Flashcube

To take flash picture with flashcube, set Shutter Speed Ring (D) at " picture of flash bulb", and the shutter speed is

set automatic ally at 1/30sec., suitable for flash pictures. Then, turn Auto/Manual Ring (B) and select the proper f-

stop. The proper f-stop can be obtained by the following calculation.

F-stop divided by Guide No. 21 m (or 65 ft.) by Distance between camera and subject (in meters or ft.)

Set Auto/Manual Ring (B) to the nearest f-stop in accord ance with the value obtained by the above calculation.

Place flashcube in Flashcube Socket (F) so that 4 prongs in base of flashcube align with accommodating slots in

Flashcube Socket (F). Press flashcube gently into the socket until cube clicks into position (Fig. 10). When you

wind Film Wind Lever (M), flashcube automatic" ally rotates. If you have used some of the bulbs within the cube,

insert cube after Film Wind Lever (M) is wound, with usable bulb facing the subject -be sure to eject cube when

used bulb has reached "firing" position.

Using the normal flash bulbs

If you are using the normal flash or electronic flash,

mount the flash gun onto Accessory Shoe (G) of your

camera, and attach the connecting cord to Flash Terminal

(I) (Fig. 11). Your camera has a Direct Contact (H) built

into Accessory Shoe (G) and cordless type flash guns

may be used.

4www.butkus.org