Ricoh Aficio MP C3002 사용자 설명서 - 페이지 14

{카테고리_이름} Ricoh Aficio MP C3002에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio MP C3002 41 페이지. Papercut ricoh embedded manual
Ricoh Aficio MP C3002에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 빠른 시작 매뉴얼 (24 페이지)

페이지 인쇄

PaperCut – Ricoh Embedded Manual

2.2.11 Installing application using the Ricoh Java SD card

It is generally recommended to use the web install method described above. This section

describes how to install the application using an SD card.

To install the application using the Java SD card, you require an SD card reader/writer that

can be connected to a computer workstation. This is used to copy the embedded application

onto the device's Java SD card.

If you do not have an SD card reader, it is recommended to use the web installation method

described in section 2.2.10.

2.2.11.1 Copy application to the Ricoh Java SD Card

The Ricoh embedded application comes included with the PaperCut install. The embedded

application must be copied to the Java card so that it can be installed on the copier.

To copy the embedded application to the Java card:

Take the Java card out of the destination Ricoh copier. To do this:



Power off the device fully using the main power switch.



Take the Java Card out of SD Slot 3 on the Ricoh Copier.

On the PaperCut server, open the directory that contains the embedded application:

IMPORTANT: Open the "connection.properties" file in this folder and verify the

"server-name" and "server-ip" are set to the network name and address of the

PaperCut server. It is recommended to set the "server-name" to a name that can be

resolved by the Ricoh copier (e.g. the DNS name of the PaperCut server).

Insert your Java SD Card into an SD card reader/writer connected to your computer.

Copy the directory "403046912" onto the SD card into the directory "\sdk\dsdk\dist".

I.e. you will end up with a directory "\sdk\dsdk\dist\403046912" on the SD card.

Remove the SD card from the card reader from the computer.

2.2.11.2 Install the Embedded Application using the SD card

To install the embedded application on the Ricoh device:

1. Take the Java card to the Ricoh device.

Revision: 19

[app-dir]\providers\hardware\ricoh\403046912

2012-10-26

14 of 41