Ricoh 7000 설치 매뉴얼

{카테고리_이름} Ricoh 7000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh 7000 4 페이지. Duplex unit for machine code: g080

페이지 인쇄

Duplex Unit Type

7000

For Machine Code: G080

INSTALLATION GUIDE

Important

Check the printer nameplate to confirm the model code.

If you want to use the optional paper feed unit at the same time, install the optional paper feed unit first, and then install the duplex unit.

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Installing the Duplex Reversal Unit Stand

Check the contents of the box.

Description

Stand

Paper Guide

Short Screw

Long Screws

Duplex Reversal Unit

Duplex Feed Unit

Installation Guide (This sheet)

Remove the adhesive tape and packing materials.

Important

Do not remove the adhesive tape holding the auxiliary bar yet.

Remove it in step

Do not remove the adhesive tape holding the cable of the du-

plex reversal unit yet. Remove it in step

Duplex Reversal Unit.

Duplex Reversal Unit

Duplex Feed Unit

(Code: G348)

Q'ty

Installing the Duplex Reversal Unit.

Installing the

ZDJP711J

ZHXH221J

Caution

• Before installing options, the machine should be turned off and unplugged for at least

thirty minutes. Components inside the machine become very hot, and could result in a

burn if touched.

• When lifting the machine, use the grips on both sides. The machine could break or

cause injury if dropped.

• It is dangerous to handle the plug with wet hands. Doing this may result in receiving an

electric shock.

• Before moving the machine, unplug the power cord from the outlet. If the cord is unplugged

abruptly, it could become damaged. Damaged plugs or cords can cause an electrical or

fire hazard.

• The inside of the machine becomes very hot. Do not touch the parts label "hot surface".

Touching a "hot surface" could result in a burn.

• Do not let go of the duplex reversal unit until it is fastened in place. It could fall and cause

injury.

Turn off the power, and then unplug the power cable from

the wall outlet.

Lift the external tray in the direction of the arrow ( ), and

then remove ( ).

Remove the two small covers on the upper left cover of

the printer.

Open the upper left cover.

Remove the two small covers by pinching and pulling

them in the direction of the arrow.

Close the upper left cover.

Note

You cannot use the two removed covers.

ZDJP038J

ZHXH230J

ZHXH241J

G348-8600