Ricoh 7000 설치 매뉴얼 - 페이지 3

{카테고리_이름} Ricoh 7000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh 7000 4 페이지. Duplex unit for machine code: g080

While supporting the duplex reversal unit, remove the

stopper of the printer's mounting bracket.

This stopper will be used in a later step

While supporting the duplex reversal unit, remove the

adhesive tape, and then hold the auxiliary bar in front of

the hook on the left side, and then stand it up.

Hook the hole of the auxiliary bar onto the printer's

mounting bracket.

In step

, move the auxiliary bar to the position with the perforated line, as

shown.

Hang the auxiliary bar on the far left end, as shown, and

then install the stopper removed in step

Make sure the auxiliary bar and stopper are installed in the positions, as shown.

ZDJP046J

, so take care not to lose it.

ZDJP047J

ZDJP048J

ZDJP049J

Slowly raise the duplex reversal unit, and then fold it up

to the printer.

Remove the adhesive tape holdings the cable, and then

connect the cable from the duplex reversal unit to the

upper connector on the back of the printer.

This completes installation of the duplex reversal unit. Install the duplex feed

unit after the external tray.

Install the external tray.

Stand the external tray, and then insert it from the

left side using both hands.

Pushing the right edge of the external tray

lightly with your finger (

ZDJP050J

ZHXH260J

ZHXH270J

), insert it (

ZDJP053J