Ricoh Container Stacker 포장 풀기 및 설정 지침 - 페이지 23
{카테고리_이름} Ricoh Container Stacker에 대한 포장 풀기 및 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Container Stacker 49 페이지.
페이지 인쇄
20. Disconnect the 4 pin white connector of the DC IF cable of the Printer from the
FNS IF cable (Disconnection 1 on the figure below), then connect it to the RB
cable of the 4 pin white connector coming from Container Stacker (Connection 5
on the following illustration) (70/92 ppm only).
NOTE
Put the cable through opening "A" of the Printer.
On SW1 mounted on the CPXXX P/K, set switch No. 5 to ON and set switch No. 2
and No. 8 to OFF. (Front Engine of 184 ppm printer)
21. Connect the CS relay cable of accessory box of the printer to the 4 pin white
connector of the FNS IF cable and the RB cable of the 4 pin white translucent
connector of the Container Stacker (Connection 5 on the following illustration.)
(184ppm only)
70/92 ppm
CTS AC Cable
Connection 1
Connection 2
CE AC Cable
CST FG Cable
DC IF Cable
CE AC Cable
J23
CST AC Cable
Connector : 2 pin white
PS
1-18
Container Stacker Installation Instructions
:
M4 Screw
Opening A
(Connection 3)
RB Cable
Connection 5
(4 pin white)
Connector : 2 pin
FNS IF Cable
Disconnection 1
(4 pin white)
Connection 1 and 2 Details
Disconnection 2
(4 pin white)
Connection 4
(20 pin black)
Disconnection 3
(2 pin white)