Ricoh Container Stacker 포장 풀기 및 설정 지침 - 페이지 22

{카테고리_이름} Ricoh Container Stacker에 대한 포장 풀기 및 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Container Stacker 49 페이지.

12. Remove the OC P/K ass'y from the Printer. Remove the CP411 P/K and CP P/K

holder (70 ppm only).

13. Remove the OC P/K ass'y and CP P/K holder from the Printer (92/184 ppm only).

14. Remove the nv-RAM from the CP411 P/K using an IC gripper. Install the

removed nv-RAM into the CP417 P/K (70 ppm only)

CST AC Cable

15. Connect the CST AC cable coming from the Container Stacker to J236 on the

power supply of the Printer (Connection 1 on the figure below). At this time,

connect the CE AC cable that was disconnected from J236 to the connector of the

CST AC cable (Connection 2 on the figure below).

16. Mount the CST FG cable coming from Container Stacker side on the Printer

frame using an M4 screw (Connection 3 on the following illustration).

17. Install the CP417 P/K on the CP P/K holder, and then install it and the board in

the Printer. (70 ppm only)

18. Install the CP P/K holder and OC P/K ass'y in the Printer (92/184 ppm only)

19. Connect the FNS IF cable of the 20 pin black connector coming from the Printer

to the J680 connector of ST09X board in Container Stacker (Connection 4 on the

figure below). Do not use the 4 pin white connector (Disconnection 2 on the

following illustration).

CP P/K holder

CPXXX P/K

CST FG Cable

Container Stacker Installation Instructions 1-17

M4 Screw

OC P/K ass'y

Dent side

nv-RAM

M4 Screw