Ricoh DDP 92 사용자 설명서 - 페이지 9
{카테고리_이름} Ricoh DDP 92에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh DDP 92 20 페이지. 70e/92/184
Ricoh DDP 92에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 프로그래밍 매뉴얼 (40 페이지), 사용자 설명서 (23 페이지)
페이지 인쇄
Chapter 2. General Information
2.1. Powering on the Finisher
If your Finisher is connected to a DDP 70/92, turn the finisher on and off using the
switch on the printer. The mark on the switch represents the binary characters "O" for
off and "I" for on.
If your Finisher is connected to a DDP 184, turn the finisher on and off using the Main
Power Switch. The mark on the switch represents the binary characters "O" for off and
"I" for on.
When the printer is powered on, the printer and the finisher go through a power-up
sequence that takes approximately 5 minutes. During the power-up sequence, the
printer will run a series of internal tests.
CAUTION:
Wait at least 5 seconds to power on the printer after powering off.
When the printer cannot be powered on, POWER OFF the printer and wait at least
30 seconds. Then power on the printer again.
F
F i n i s h e r F
Finisher
F i n i s
F i n i s h F i n i F I e r
Finisher
Main Power Switch
WARNING:
In the event of an emergency, POWER OFF the printer by turning the Power
Switch to'O' side. The printer can be always powered off by turning the Power
Switch to 'O' side.
O G
V 1
P o w e r
P O P o w e r
P P
P o w e r S w i t c h P o w e r S w i t c h
P o
0 0
Power Switch
2-1