Ricoh DDP 92 User Manual - Page 9
Browse online or download pdf User Manual for Printer Accessories Ricoh DDP 92. Ricoh DDP 92 20 pages. 70e/92/184
Also for Ricoh DDP 92: Brochure & Specs (4 pages), Programming Manual (40 pages), User Manual (23 pages)
Print Page
Chapter 2. General Information
2.1. Powering on the Finisher
If your Finisher is connected to a DDP 70/92, turn the finisher on and off using the
switch on the printer. The mark on the switch represents the binary characters "O" for
off and "I" for on.
If your Finisher is connected to a DDP 184, turn the finisher on and off using the Main
Power Switch. The mark on the switch represents the binary characters "O" for off and
"I" for on.
When the printer is powered on, the printer and the finisher go through a power-up
sequence that takes approximately 5 minutes. During the power-up sequence, the
printer will run a series of internal tests.
CAUTION:
Wait at least 5 seconds to power on the printer after powering off.
When the printer cannot be powered on, POWER OFF the printer and wait at least
30 seconds. Then power on the printer again.
F
F i n i s h e r F
Finisher
F i n i s
F i n i s h F i n i F I e r
Finisher
Main Power Switch
WARNING:
In the event of an emergency, POWER OFF the printer by turning the Power
Switch to'O' side. The printer can be always powered off by turning the Power
Switch to 'O' side.
O G
V 1
P o w e r
P O P o w e r
P P
P o w e r S w i t c h P o w e r S w i t c h
P o
0 0
Power Switch
2-1