Cisco 12016 사용 설명서 - 페이지 9

{카테고리_이름} Cisco 12016에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 12016 16 페이지. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Cisco 12016에 대해서도 마찬가지입니다: 포장 풀기 사용 설명서 (28 페이지), 데이터시트 (9 페이지), 교체 지침 매뉴얼 (32 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Use the 3/4-inch (19-mm) socket and ratchet wrench to turn the scissor-jack screw slowly

Step 5

counterclockwise to expand the scissor-jack platform and raise the top of the scissor-jack platform high

enough for the hold-down brackets to clear the top of the pallet body.

Slide the pallet body around the scissor-jack platform.

Step 6

Step 7

Slide the pallet front bar into the opening on the pallet body and use the hinge locks to secure it as

instructed in these steps:

Pivot the butterfly handle on the hinge lock up so that it is perpendicular to the body of the hinge

lock.

Twist the butterfly handle counterclockwise to extend the hinge lock hook to its maximum reach.

Lower the hinge lock hook over the hinge lock catch on the pallet body.

Twist the butterfly handle clockwise to clamp the hinge lock hook on the hinge lock catch on the

pallet body.

Pivot the butterfly lever down onto the hinge lock body so that it lies flat.

Shift the pallet to ensure that it is positioned evenly all the way around the scissor-jack platform and that

Step 8

the bolt holes in the hold-down brackets on the sides of the scissor-jack platform are aligned with the

holes in the top of the shipping pallet.

Turn the scissor-jack screw slowly clockwise to close the scissor-jack platform and lower the top of the

Step 9

scissor-jack platform slowly until the hold-down brackets touch the top of the shipping pallet.

Set a blocking plate into the hold-down bracket so that the blank side of the blocking plate is against the

Step 10

heads of the bolts in the side of the scissor-jack platform, and the open holes in the blocking plate align

with the bolt holes in the top of the pallet.

Insert bolts through each of the hold-down bracket holes and into the holes in the top of the shipping

Step 11

pallet, then use the 9/16-inch (14-mm) wrench to tighten the bolts.

Step 12

Turn the scissor-jack screw slowly clockwise to collapse the scissor-jack platform and raise the base of

the scissor-jack platform until the weight of the router and scissor-jack platform is absorbed by the

pallet. Continue turning the scissor-jack screw clockwise to close the scissor-jack platform and lift the

base of the scissor-jack platform until the scissor-jack platform is completely closed (the screw can not

be turned).

78-15717-01

Cisco 12016, Cisco 12416, and Cisco 12816 Router Scissor-Jack Instructions

Using the Scissor-Jack Platform