Cisco 12816 교체 지침 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 12816에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 12816 32 페이지. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Cisco 12816에 대해서도 마찬가지입니다: 포장 풀기 사용 설명서 (28 페이지), 데이터시트 (9 페이지), 사용 설명서 (16 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Preparing for Installation

Always place a card component-side-up on an antistatic surface, in an antistatic card rack, or in a

•

static shielding bag. If you are returning the item to the factory, immediately place it in a static

shielding bag.

When installing a line card or RP, use the ejector levers to seat the card connectors in the backplane,

•

then tighten both captive screws on the faceplate of the card. These screws prevent accidental

removal, provide proper grounding for the router, and help to ensure that the card connector is seated

in the backplane.

When removing line cards, CSCs, SFCs, or an RP, use the ejector levers to unseat the card connector

•

from the backplane. Pull the metal card carrier out slowly, placing one hand along the bottom of the

carrier to guide it straight out of the slot.

•

Handle line cards, CSCs, SFCs, or an RP by the metal card carrier edges only; avoid touching the

board or any connector pins.

Figure 2

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

Connecting an ESD-Preventive Wrist Strap to the Router

ESD

connection

socket

78-16082-01